What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 26.06.2025 13:56

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
In schematic diagrams this is the symbol for a fuse:
2024–10–16 [ OO OLAOYE OYEBODE ]
Splitgate 2 developer 1047 Games lays off "small group of valued staff" - Eurogamer
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
but I think this circuit , shows a few more pieces.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Fat composition in ketogenic diet may influence outcomes in MS - Multiple Sclerosis News Today
But it can get overloaded, and no longer works.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
This one hit behind the barn.
Is there any concrete proof that LED face masks actually work?
What does a fuse do?
nine
There are three different concepts here that are getting confused.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
At one ohm, the resistor has a maximum of 1 watt power.
Isn’t freedom of speech and expression an absolute right?
This is the picture of an electronic coil of wire wound around a core of magnetic material.
At least they know the answer if they wanted it.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
A circuit breaker is similar, but is resettable.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Here is a simplified AC power diagram.
How come Jesus died on Friday and rose on Sunday? That's not 3 days and three nights.
(Dc diagram shown, AC is similar).
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Michaels acquires Joann’s intellectual property, private label brands - WSB-TV
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
First Sentence:
[image of Common-mode choke]
but this device (an Inductor) … impedes the rapid changes in the current.
so, what happens?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
These are simplified answers to the original question, and does not change anything I wrote above.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
‘My heart is broken’: Customers reeling as General Mills discontinues 3 cereals - OregonLive.com
One is “what exactly is in a ‘surge protector’ ? ”
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
What are the upcoming trends in artificial intelligence and machine learning?
The other is “what does a “fuse” do?”
The third is lightning and “how it gets conducted into a home.”
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This device then solves the entire problem.
It seems Mohan does not understand the difference between a comment and an Answer.
So, the voltage could go up to 500 volts, and the fuse will not open up.
A fuse is a non-resetable over current circuit protector.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
These devices are installed between the “hot” and “neutral” and protective ground.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
An AC voltage/ current source, and an ac inductive load.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This is 'the assistant's answer'
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Upvotes:
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
It also is a device that limits the change in current flow.
what exactly is a ‘surge’ protector?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
[old diagram got deleted by accident]
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This is where this question deviates from being a 'generic' question, and becomes more specific.
This is where the MOV conducts again, and dissipated the energy.
a photo is worth a thousand words.
He then asserts :
There are two important concepts here.
Now when you have a certain ac resistance, then a current flows in a loop.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Because the load is inductive, the current lags the voltage.(by a bit).
eight
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
For this case there are devices called Metal oxide varistors (MOV).
2024–10–10[John johnson John Johnson ]
Barnstars:
But… the neutral is now “floating” because of the 1 ohm resistance.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
the problem then depends on "how fast does the fuse operate?".
Edit 2024–10.
What is lightning?
He then describes the function of a fuse.
One
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
I post the exact comment here.
He then describes Rainy Season and Lightning.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
The bolt then partially travels down the line to your home.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?